· Direct drive conveyor assembly.
· Roller diameter (inches) 6.0-8.0
· Pneumatic requirements: 80 PSI.
· Support roller idler (inches) 5.0-12.0
· Stamping roller width (inches) 1.0-12.0
· Standard conveyor lengths (feet) 4.0-6.0
· Standard conveyor widths (inches) 3.0-12.0
· Adjustable height off conveyor (inches) 0-6.0
· Electrical requirements: 240 VAC single phase.
· Tracking adjustment  with 3.0 (inches) diameter rollers.
· Approximate size (inches) 36 x 30 x 66 x with 54 or 72 OAL weight:970 lbs.

Operating Features

· (Variable speed) DC drive.
· (Roll-leaf advance) with adjustable height, jog, tension, and auto rewind driven.
· (Positioning unwind) for standard 1" or 3" cores.
· (Quick change over) for heated roller.
· (Solid state digital) temperature controller with thermocouple.
· (Control panel) with easy access for operator, bright led display with soft touch set-points
in temperature controller, run, roller controls, and "E stop" disconnect.
· (Maintained safety) air cooling on heater roller system.
· (Radiant type) ceramic heat in stainless steel housing.
· (Construction) steel frame weldment, 4 post  section with aluminum upright, leveling pads, and all necessary
guarding. 

Other Options Available

	(Variable speed) DC drive.
	(Roll-leaf advance) with adjustable height, jog, tension, and auto rewind driven.
	(Positioning unwind) for standard 1" or 3" cores.
	(Quick change over) for heated roller.
	(Solid state digital) temperature controller with thermocoupler.
	(Control panel) with easy access for operator, bright led display with soft touch set-points in temperature controller, run, roller controls, and "E stop" disconnect.
	Maintained safety) air cooling on heater roller system.
	(Radiant type) ceramic heat in stainless steel housing.
	(Construction) steel frame weldment, 4 post  section with aluminum upright, leveling pads, and all necessary guarding.