Large Capacity Roll Leaf Cutting Machine

Vansco Inc.

Specifications

· Handles up to 12” diameter rolls by 50” master width.

· Non rotating support mandrel for 1” and 3” cores.

· Large radius “T slot” to jaw steel clamping assembly, coated.

· Heavy ⅞” diameter clamping screw.

· Manual cutting arm control with pneumatic force setting.

· Heavy duty synchronous drive with 1.5 driver.

· ¾ thick plating for strength on drive side.

· Fixed/rotating blade assembly for various roll conditions.

· Complete with 10” OD x 1” hardened blade for up to 9.5 OD rolls.

· Stop positions for blade travel.

· Quick 5 ft. reference measure scale with location indicator.

· 1” diameter guide rods with linear ball bushings to provide cutting stability.

· 1 ½” carriage plate with 1 ½” diameter Thompson shafting and support rails.

· Pillow block bearings provide smooth and accurate movement for width position and strength.

· 1 ½ HP, 180 VDC PM motor.

· Variable speed controller for various roll conditions.

· Easy to operate.

· Ships fully assembled ready to cut.

· Electrical requirements: Wired 240 VAC single phase.

· Pneumatic requirements: 80 PSI.

· All safety guarding as required.

Machine Options

· Filtered control air, minimizes heat and material at blade edge.

· Magnetic liner encoder with sensor, large display reader 4 decimal place for precise width location.

· Motor controller with forward/reverse and braking motor.

· 13” or 15” OD x 1” ID single ⅝ bevel hardened round blade.

· Additional safety guarding for operator.

Vansco Inc.

138 B Cannonball Road. Pompton Lakes, NJ 07442

Phone: (973) 835-8423

Fax: (973) 835-8765